Dear Alberto and all,
I just tested with specview (2.12.2) to answer the question by Alberto. (I didnīt remeber if I had lost something in item (iii) The answer is about specview:
i) it is needed a "name" in the table tag (or maybe in any other place)
ii) it is needed the utype in X
iii) it is needed the utype in Y
so
> Was (ii) to be counted twice or (iii) was left in your fingertips?
The minimal VOTable it manage is:
<?xml version='1.0'?>
<VOTABLE version="1.1"
xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance"
xsi:schemaLocation="http://www.ivoa.net/xml/VOTable/v1.1 http://
www.ivoa.net/xml/VOTable/v1.1"
xmlns="http://www.ivoa.net/xml/VOTable/v1.1">
<RESOURCE>
<TABLE name="hola2">
<FIELD datatype="float" name="WAVE" unit="0.1nm"
utype="sed:Segment.Points.SpectralCoord.Value"/>
<FIELD datatype="float" name="FLUX" unit="erg/s/0.1nm/cm2"
utype="sed:Segment.Points.Flux.Value"/>
<DATA>
<TABLEDATA>
.....
Surprisely I had found that specview is not able to manage the VOTables generated by itself at least in ascii!! At leats for the table i had donwload (first HTS data from I zw 18), the VOTable that is obtained when it is saved produce two <TABLE> elements, and specview only manage the first one with observational metadata. I had need to load the table in TopCat and save it again with topcat to obtain a VOTable that spceview reads.
Any case I will try to repeat the exercise again in some weeks ...
cheers
Miguel Received on 2006-11-16Z12:19:31